任何機械都是有不同的配件組成的，裝載機也不例外，裝載機的增壓器是裝載機的重要部件，需要大家好好保養才能發揮它的重要作用，那么應該如何進行保養呢？

1、增壓器要保持清潔。經常注意檢查增壓器的運轉情況，在出車前、收車后，應檢查氣道各管的連接情況，防止松動、脫落而造成增壓器失效和空氣短路進入氣缸。
Always pay attention to check the functioning of the turbocharger, in front of the bus, after closing the car, check the connections of each airway tube to prevent loosening, shedding booster failure caused by a short circuit and air into the cylinder.
2、不能立即熄火。發動機工作時,有一部分機油供給渦輪增壓器轉子軸承潤滑和用于冷卻的。所以發動機長時間高速運轉后,不能立即熄火。
When the engine work, some of the oil supply turbocharger rotor bearings for lubrication and cooling. So after a long high-speed operation of the engine, can not turn off immediately.　　
3、由于增壓器經常處于高溫下運轉,它的潤滑油管線因受高溫作用,內部機油容易有部分的結焦,這樣會造成增壓器軸承的潤滑不足而損壞。因此,潤滑油管線在運行一段時間后要進行清洗。
Due to high temperatures often in the turbocharger operation, its oil pipeline due to high temperature, internal oil prone parts of coke, this will result in insufficient lubrication of the bearing turbocharger damage. Thus, oil pipeline after running for some time to be cleaned.　　
4、不能著車就走。發動機發動后,特別是在冬季,應讓其怠速運轉一段時間,以裝載機配件便在增壓器轉子高速運轉之前讓潤滑油充分潤滑軸承。所以剛啟動后千萬不能猛轟油門,以防損壞增壓器油封。
After the engine is started, especially in the winter, should be allowed to idle for a period of time to loader accessories will be in operation before the turbocharger rotor speed sufficient to allow oil-lubricated bearings. So do not start just after Meng throttle to prevent damage to the turbocharger oil seal.

 濟南裝載機配件：http://www.lcsqtax.cn/